Command Line Reference Guide

Related
Commands
ip pim sparse-mode – enables IGMP and PIM on an interface.
show ip mroute
View the multicast routing table.
S5000
Syntax
show ip mroute [static | group-address [source-address] |
active [rate] | summary]
Parameters
static (OPTIONAL) Enter the keyword static to view static multicast
routes.
group-address
[
source-address
]
(OPTIONAL) Enter the multicast group-address to view only routes
associated with that group.
Enter the source-address to view routes with that group-address and
source-address.
active [
rate
] (OPTIONAL) Enter the keyword active to view only active multicast
routes. Enter a rate to view active routes over the specified rate. The
range is 0 to 10000000.
summary (OPTIONAL) Enter the keyword summary to view routes in a tabular
format.
Command Modes
EXEC
EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example (Static)
FTOS#show ip mroute static
Mroute: 23.23.23.0/24, interface: Lo 2
Protocol: static, distance: 0, route-map: none, last change:
00:00:23
Example
(Snooping)
FTOS#show ip mroute snooping
IPv4 Multicast Snooping Table
(*, 224.0.0.0), uptime 17:46:23
Incoming vlan: Vlan 2
Outgoing interface list:
TenGigabitEthernet 4/13
(*, 225.1.2.1), uptime 00:04:16
Incoming vlan: Vlan 2
880