Command Line Reference Guide

connect-source
interface
Enter the keywords connect-source followed by one of the
interfaces and slot/port or number information:
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
For a Port Channel interface, enter the keywords port-
channel followed by a number. The range is 1 to 128.
For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
description name
(OPTIONAL) Enter the keyword
description
followed by a description
name (maximum 80 characters) to designate a description for the
MSDP peer.
sa-limit
number
(OPTIONAL) Enter the maximum number of SA entries in SA-cache.
The range is 1 to 500000. The default it 500000.
Defaults as above
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The connect-source option is used to supply a source IP address for the TCP connection.
When an interface is specified using the
connect-source option, the primary configured
address on the interface is used.
If the total number of SA messages received from the peer is already larger than the limit when
this command is applied, those SA messages continue to be accepted. To enforce the limit in
such situation, use the clear ip msdp peer command to reset the peer.
Related
Commands
ip msdp sa-limit – configures the MSDP SA Limit.
clear ip msdp peer – clears the MSDP peer.
show ip msdp – displays the MSDP information.
857