Command Line Reference Guide
ip msdp originator-id
Configure the MSDP Originator ID.
S5000
Syntax
ip msdp originator-id {interface-type slot/port}
To remove the originator-id, use the no ip msdp originator-id {interface-
type slot/port} command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
ip msdp peer
Configure an MSDP peer.
S5000
Syntax
ip msdp peer peer address [connect-source] [description] [sa-
limit number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-
source interface] [description name] [sa-limit number] command.
Parameters
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.).
856