Command Line Reference Guide
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command followed by the ip msdp cache-rejected-sa
{
number} command.
Parameters
number
Enter the number of rejected SA entries to cache. The range is 0 to
32766.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
show ip msdp sa-cache rejected-sa
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
S5000
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address}
list name command.
Parameters
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)
list
name
Enter the keywords list name and specify a standard access list
that contains the RP address that should be treated as the default
peer. If no access list is specified, then all SAs from the peer are
accepted.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If a list is not specified, all SA messages received from the default peer are accepted. You can
enter multiple default peer commands.
854