Command Line Reference Guide

multiplier 3
no disable
FTOS#
LLDP-MED Commands
The following are the LLDP-MED (Media Endpoint Discovery) commands.
FTOS LLDP-MED commands are an extension of the set of LLDP TLV advertisement commands. The S5000 switch
supports all commands.
As defined by ANSI/TIA-1057, LLDP-MED provides organizationally specific TLVs (Type Length Value), so that endpoint
devices and network connectivity devices can advertise their characteristics and configuration information. The
Organizational Unique Identifier (OUI) for the Telecommunications Industry Association (TIA) is 00-12-BB.
LLDP-MED Endpoint Device — any device that is on an IEEE 802 LAN network edge, can communicate using IP,
and uses the LLDP-MED framework.
LLDP-MED Network Connectivity Device — any device that provides access to an IEEE 802 LAN to an LLDP-
MED endpoint device, and supports IEEE 802.1AB (LLDP) and TIA-1057 (LLDP-MED). The Dell Networking system
is an LLDP-MED network connectivity device.
With regard to connected endpoint devices, LLDP-MED provides network connectivity devices with the ability to:
manage inventory
manage Power over Ethernet (POE)
identify physical location
identify network policy
advertise med guest-voice
Configure the system to advertise a separate limited voice service for a guest user with their own IP telephony handset
or other appliances that support interactive voice services.
S5000
Syntax
advertise med guest-voice {vlan-id layer2_priority DSCP_value}
| {priority-tagged number}
To return to the default, use the no advertise med guest-voice {vlan-id
layer2_priority DSCP_value
} | {priority-tagged number} command.
Parameters
vlan-id
Enter the VLAN ID. The range is 1 to 4094.
layer2_priority
Enter the Layer 2 priority. The range is 0 to 7.
DSCP_value
Enter the DSCP value. The range is 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged followed the Layer 2
priority. The range is 0 to 7.
846