Command Line Reference Guide
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
S5000
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer
Enter the number of consecutive misses before the LLDP declares the
interface dead. The range is 2 to 10.
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
interface
-lldp)
Command History
Version 9.0(1.3) Introduced on the S5000.
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
S5000
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Disabled.
Command Modes CONFIGURATION (conf-lldp)
Command History
Version 9.0(1.3) Introduced on the S5000.
protocol lldp (Interface)
Enter the LLDP protocol in INTERFACE mode.
S5000
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp command
from Interface mode.
843