Command Line Reference Guide

hello
Configure the rate at which the LLDP control packets are sent to its peer.
S5000
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Enter the rate, in seconds, at which the control packets are sent to its
peer. The rate is 5 to 180 seconds. The default is 30 seconds.
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
interface
-lldp)
Command History
Version 9.0(1.3) Introduced on the S5000.
mode
Set LLDP to receive or transmit.
S5000
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Defaults Both transmit and receive.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
interface
-lldp)
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol lldp (Configuration) – enables LLDP globally.
show lldp neighbors – displays the LLDP neighbors.
842