Command Line Reference Guide

banner motd

Set a message of the day (MOTD) banner.

S5000

Syntax

banner motd c line c

Parameters

Enter the keywords banner motd, then enter a character

delimiter, represented here by the letter

. Press ENTER.

line

Enter a text string for your banner message, ending the message with

a delimiter character. In the example below, the delimiter is a percent

sign (%). Range: maximum 50 lines, up to 255 characters per line.

Defaults No banner is configured.

Command Modes CONFIGURATION

Command History

Version 9.0(1.3) Introduced on the S5000.

Usage

Information

A MOTD banner message is displayed only in EXEC Privilege mode after entering the enable

command followed by the password. These banners are not displayed to users in EXEC (non-

privilege) mode.

Commands

banner exec – enables the display of a text string when you enter EXEC mode.

banner login – sets a banner to be displayed after successful login to the system.

cam-audit stack-unit

Enable audit of the IPv4 and IPv6 forwarding table on all stack-units.

Syntax

cam-audit stack-unit [all | ipv4-fib | ipv6-fib] interval time-

in-minutes

Parameters

all Enter the keyword all to enable CAM audit on all stack-units.

ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on the

IPv4 forwarding entries.

ipv6-fib Enter the keyword ipv6-fib to designate the CAM audit on the

IPv6 forwarding entries.

interval

time-in-

minutes

Enter the keyword interval followed by the frequency in minutes

of the CAM audit. Range: 5 to 1440 minutes (24 hours). Default:

minutes.