Command Line Reference Guide

Parameters
normal (OPTIONAL) Enter the keyword normal to change the link state to
“unknown” when a far-end failure is detected by the software on that
interface. When the interface is placed in “unknown” state, the
software brings down the line protocol.
aggressive (OPTIONAL) Enter the keyword aggressive to change the link
state to “error-disabled” when a far-end failure is detected by the
software on that interface. When an interface is placed in “error-
disabled” state, you must enter the
fefd reset command to reset
the interface state.
Defaults normal
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
fefd – enables far-end failure detection.
fefd reset
Reset all interfaces or a single interface that was in “error-disabled” mode.
S5000
Syntax
fefd reset [interface-type slot/port]
Parameters
interface-type
slot/port
(OPTIONAL) Enter one of the following keywords and slot/port or
number information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
834