Command Line Reference Guide
fefd-global
Enable FEFD globally on the system.
S5000
Syntax
fefd-global [mode {normal | aggressive}]
To disable FEFD globally, use the no fefd-global [mode {normal |
aggressive}] command.
Parameters
normal (OPTIONAL) Enter the keywords mode normal to change the link
state to “unknown” when a far-end failure is detected by the
software on that interface. When the interface is placed in
“unknown” state, the software brings down the line protocol. The
default is Normal mode.
aggressive (OPTIONAL) Enter the keywords mode aggressive to change the
link state to “error-disabled” when a far-end failure is detected by the
software on that interface. When an interface is placed in “error-
disabled” state, you must enter the
fefd reset command to reset
the interface state.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you enter only the fefd-global syntax, the mode is normal and the default interval is 15
seconds.
If you disable FEFD globally (no fefd-global), the system does not remove the FEFD
interface configuration.
Related
Commands
• fefd – enables far-end failure detection.
• fefd-global interval – configures an interval between FEFD control packets.
• show fefdshow fefd – shows the FEFD command output.
fefd-global interval
Configure an interval between FEFD control packets.
S5000
Syntax
fefd-global interval seconds
To return to the default value, use the no fefd-global interval command.
832