Command Line Reference Guide

EXEC Privilege
Example
FTOS#show cam mac stack-unit 0 port-set 0
VlanId Mac Address Region Interface
0 5c:f9:dd:ee:ff:c2 LOCAL_DA 00001
0 ff:ff:ff:ff:ff:ff STATIC 00001
0 00:10:18:ff:ff:ff STATIC N/A
FTOS#
Command History
Version 9.0(1.3) Introduced on the S5000.
show mac-address-table
Display the MAC address table.
S5000
Syntax
show mac-address-table [dynamic | static] [address mac-address
| interface type slot/port | vlan vlan-id] [count [vlan vlan-
id ]]]
Parameters
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch. Optionally, you can
also add one of these combinations:
address/mac-address,
interface/interface, or vlan vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC
address specifically configured on the switch. Optionally, you can
also add one of these combinations: address/mac-address,
interface/interface, or vlan vlan-id.
address
mac-
address
(OPTIONAL) Enter the keyword address followed by a MAC
address in the nn:nn:nn:nn:nn:nn format to display information on that
MAC address.
interface
type
slot/port
(OPTIONAL) Enter the keyword interface followed by the
interface type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are listed
below.
For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
817