Command Line Reference Guide

To remove a MAC address, use the no mac-address-table static mac-address
output interface-type slot/port vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format.
output interface-
type slot/port
Enter the keyword output followed by one of the following
interfaces:
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
vlan vlan-id Enter the keyword vlan followed by a VLAN ID number from 1 to
4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
show mac-address-table – displays the MAC address table.
mac-address-table station-move threshold
Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A
trap is sent if a station move is detected above a threshold number of times in a given interval.
S5000
Syntax
[no] mac-address-table station-move threshold number interval
count
Parameters
threshold number Enter the keyword threshold followed by the number of times
MAC addresses in VLANs can change before an SNMP trap is sent.
The range is 1 to 10.
interval seconds Enter the keyword interval followed by the number of seconds.
The range is 5 to 60.
Defaults Not configured.
Command Modes CONFIGURATION
811