Command Line Reference Guide

Control and Monitoring

This chapter contains the commands to configure and monitor the system, including Telnet, file transfer protocol (FTP),

and trivial file transfer protocol (TFTP) as they apply to the S5000 switch.

NOTE: The enable xfp-power-updates command was deprecated for the S5000. This command was

replaced by the enable optic-info-update interval command to update information on temperature

and power monitoring in the simple network management protocol (SNMP) management information base (MIB).

asf-mode

Enable Alternate Store and Forward (ASF) mode and forward packets as soon as a threshold is reached.

S5000

Syntax

asf-mode stack-unit {unit-number | all} queue size

To return to standard Store and Forward mode, use the no asf-mode stack unit

command.

Parameters

stack-unit

unit-

number

Enter the keywords stack-unit followed by the stack-unit number

to reset. The range is 0 to 11. Enter all to reset all the stack-units.

NOTE: The S5000 commands accept Unit ID numbers 0 to 11,

although the S5000 supports stacking of up to six units with FTOS

version 9.0(1.3).

queue size Enter the queue size of the stack member. The range is 0 to 15.

Defaults Not configured

Command Modes CONFIGURATION

Command History

Version 9.0(1.3) Introduced on the S5000.

Usage

Information

You

must

save the configuration and reload the system to implement ASF. When you enter the

command, the system sends a message stating that the new mode is enabled when the system

reloads.