Command Line Reference Guide

30
Layer 2
This chapter describes commands to configure Layer 2 features.
This chapter contains the following sections:
• MAC Addressing Commands
• Virtual LAN (VLAN) Commands
• Far-End Failure Detection (FEFD)
The VLAN commands are supported on the S5000 Dell Networking switch.
MAC Addressing Commands
The following commands are related to configuring, managing, and viewing MAC addresses.
clear mac-address-table dynamic
Clear the MAC address table of all MAC address learned dynamically.
S5000
Syntax
clear mac-address-table {dynamic | sticky }{address mac-address
| all | interface type slot/port | vlan vlan-id}
Parameters
dynamic Enter the keyword dynamic to specify dynamically-learned MAC
addresses.
sticky Enter the keyword sticky to specify sticky MAC addresses.
address mac-
address
Enter the keyword address followed by a MAC address in
nn:nn:nn:nn:nn:nn format.
all Enter the keyword all to delete all MAC address entries in the MAC
address table.
interface type
slot/port
Enter the interface keyword followed by the interface type and
slot/port or number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
809