Command Line Reference Guide

Defaults 32768
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
port-channel mode
Configure the LACP port channel mode.
S5000
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords port-channel followed by a number. The
range is 1 to 128.
active Enter the keyword active to set the mode to the active state.
NOTE: LACP modes are defined in Usage Information below.
passive Enter the keyword passive to set the mode to the passive state.
NOTE: LACP modes are defined in Usage Information below.
off Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information below.
Defaults off
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
LACP Modes
active An interface is in an active negotiating state in this mode. LACP runs
on any link configured in the active state and also automatically
initiates negotiation with other ports by initiating LACP packets.
passive An interface is not in an active negotiating state in this mode. LACP
runs on any link configured in the passive state. Ports in a passive
state respond to negotiation requests from other ports that are in
active states. Ports in a passive state respond to LACP packets
off An interface can not be part of a dynamic port channel in off mode.
LACP does not run on a port configured in off mode.
806