Command Line Reference Guide

Defaults 1 second

Command Modes INTERFACE (conf-if-po-number)

Command History

Version 9.0(1.3) Introduced on the S5000.

Usage

Information

This command applies to dynamic port-channel interfaces only. When applied on a static port-

channel, this command has no effect.

Commands

show lacp – displays the lacp configuration.

lacp port-priority

Configure the port priority to influence which ports will be put in standby mode when there is a hardware limitation that

prevents all compatible ports from aggregating.

S5000

Syntax

lacp port-priority priority-value

To return to the default setting, use the no lacp port-priority priority-value

command.

Parameters

priority-value

Enter the port-priority value. The higher the value number, the lower

the priority. The range is 1 to 65535. The default is 32768.

Defaults 32768

Command Modes INTERFACE