Command Line Reference Guide

To disable LACP debugging, use the no debug lacp [config | events | pdu
[interface-type slot/port][in | out]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP event
information.
pdu in | out (OPTIONAL) Enter the keyword pdu to debug the LACP Protocol Data
Unit information. Optionally, enter an
in or out parameter to:
Receive enter in
Transmit enter out
interface-type
slot/port
(OPTIONAL) Enter one of the following keywords followed by slot/port
or number information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
Optionally, enter an in or out parameter:
Receive enter in
Transmit enter out
Defaults none
Command Modes
EXEC
EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
S5000
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout
command.
804