Command Line Reference Guide

Link Aggregation Control Protocol (LACP)

This chapter contains commands for Dell Networking’s implementation of the link aggregation control protocol (LACP)

for creating dynamic link aggregation groups (LAGs)—known as “port-channels” in the Dell Networking operating

software [FTOS]. The LACP commands in this chapter are supported by FTOS on the S5000 switch.

NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter), based on the

standards specified in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access

method and physical layer specifications.

clear lacp counters

Clear Port Channel counters.

S5000

Syntax

clear lacp port-channel-number counters

Parameters

port-channel-

number

Enter a port-channel number: The range is 1 to 128.

Defaults Without a Port Channel specified, the command clears all Port Channel counters.

Command Modes

• EXEC

• EXEC Privilege

Command History

Version 9.0(1.3) Introduced on the S5000.

Commands

show lacp – displays the lacp configuration.

debug lacp

Debug LACP (configuration, events, etc.)

S5000

Syntax

debug lacp [config | events | pdu [interface-type slot/port][in

| out]]

803