Command Line Reference Guide

show isis traffic
This command allows you to display IS-IS traffic interface information.
S5000
Syntax
show isis traffic [interface-type slot/port]
Parameters
interface-type
slot/port
(OPTIONAL) Enter one of the following keywords followed by slot/port
or number information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show isis traffic command output shown in the Example
below.
Table 8. Output Fields for the
show isis traffic Command
Field Description
Level-1/Level-2 Hellos (sent/rcvd) Displays the number
of Hello packets sent
and received
.
PTP Hellos (sent/rcvd) Displays the number
of point-to-point
Hellos sent and
received
.
Level-1/Level-2 LSPs sourced (new/refresh) Displays the number
of new and refreshed
LSPs
.
Level-1/Level-2 LSPs flooded (sent/rcvd) Displays the number
of flooded LSPs sent
and received
.
799