Command Line Reference Guide

{external | internal}] [level-1 | level-1-2 | level-2] [route-
map map-name] command.
Parameters
connected Enter the keyword connected to redistribute active routes into IS-
IS.
rip Enter the keyword rip to redistribute RIP routes into IS-IS.
static Enter the keyword static to redistribute user-configured routes
into IS-IS.
metric metric-
value
(OPTIONAL) Assign a value to the redistributed route. The range is 0
to 16777215. The default is 0. Use a value that is consistent with the
destination protocol.
metric-type
{external |
internal}
(OPTIONAL) The external link type associated with the default route
advertised into a routing domain. Specify one of the following:
• external
• internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-IS as
Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-IS as
Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as
Level 2 routes. This is the default.
route-map map-
name
(OPTIONAL) If you do not enter the route-map argument, all routes
are redistributed. If a map-name value is not specified, no routers are
imported.
Defaults
• metric metric-value = 0
• metric-type= internal; level-2
Command Modes
• ROUTER ISIS ( for IPv4 )
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 ( for IPv6 )
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To redistribute a default route (0.0.0.0/0), configure the default-information
originate command.
Changing or disabling a keyword in this command does not affect the state of the other
command keywords.
When an LSP with an internal metric is received, the FTOS considers the route cost while
considering the advertised cost to reach the destination.
Redistributed routing information is filtered with the distribute-list out command to
ensure that the routes are properly are passed to the receiving routing protocol.
786