Command Line Reference Guide

passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that interface.
S5000
Syntax
passive-interface interface-type slot/port
To delete a passive interface configuration, use the no passive-interface
interface command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For Loopback interface, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER ISIS
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Although the passive interface neither sends nor receives routing updates, the network on that
interface is still included in the IS-IS updates sent using other interfaces.
redistribute
Redistribute routes from one routing domain to another routing domain.
S5000
Syntax
redistribute {static | connected | rip} [level-1 | level-1-2 |
level-2] [metric metric-value] [metric-type {external |
internal}] [route-map map-name]
To end redistribution or disable any of the specified keywords, use the no redistribute
{static | connected | rip} [metric metric-value] [metric-type
785