Command Line Reference Guide

multi-topology
Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prefix information in the
LSPs.
S5000
Syntax
multi-topology [transition]
To return to a single topology configuration, use the no multi-topology
[transition] command.
Parameters
transition
Defaults Disabled
Command Modes CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Command History
Version 9.0(1.3) Introduced on the S5000.
net
Use this mandatory command to configure an IS-IS network entity title (NET) for a routing process. If you did not
configure a NET, the IS-IS process does not start.
S5000
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-
title
Specify the area address and system ID for an IS-IS routing process.
The first 1 to 13 bytes identify the area address. The next 6 bytes
identify the system ID. The last 1 byte is the selector byte, always
identified as zero zero (00). This argument can be applied to an
address or a name.
Defaults Not configured.
Command Modes ROUTER ISIS
Command History
Version 9.0(1.3) Introduced on the S5000.
784