Command Line Reference Guide

isis metric
Assign a metric to an interface.
S5000
Syntax
isis metric default-metric [level-1 | level-2]
To return to the default values, use the no isis metric [default-metric]
[level-1 | level-2] command.
Parameters
default-metric Metric assigned to the link and used to calculate the cost from each
other router via the links in the network to other destinations. You can
configure this metric for Level 1 or Level 2 routing. The range is 0 to 63
for narrow and transition metric styles and 0 to 16777215 for wide
metric styles. The default is 10.
level-1 (OPTIONAL) Enter the keywords level-1 to configure the shortest
path first (SPF) calculation for Level 1 (intra-area) routing. This is the
default.
level-2 (OPTIONAL) Enter the keywords level-2 to configure the SPF
calculation for Level 2 (inter-area) routing.
Defaults default-metric = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Dell Networking recommends configuring metrics on all interfaces. Without configuring this
command, the IS-IS metrics are similar to hop-count metrics.
isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
S5000
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
776