Command Line Reference Guide
Defaults Padding of hello PDUs is enabled (ON).
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Hello PDUs are “padded” only when both the global and interface padding options are ON.
Turning either one OFF disables padding for the corresponding interface.
Related
Commands
hello padding – turns ON or OFF padding for LAN and point-to-point hello PDUs.
isis ipv6 metric
Assign metric to an interface for use with IPv6 information.
S5000
Syntax
isis ipv6 metric default-metric [level-1 | level-2]
To return to the default values, use the no ipv6 isis metric [default-metric]
[level-1 | level-2]
command.
Parameters
default-metric
Metric assigned to the link and used to calculate the cost from each
other router via the links in the network to other destinations. You can
configure this metric for Level 1 or Level 2 routing. The range is 0 to
16777215. The default is 10.
level-1 (OPTIONAL) Enter the keywords level-1 to configure the shortest
path first (SPF) calculation for Level 1 (intra-area) routing. This value
is the default.
level-2 (OPTIONAL) Enter the keywords level-2 to configure the SPF
calculation for Level 2 (inter-area) routing.
Defaults default-metric = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Dell Networking recommends configuring metrics on all interfaces. Without configuring this
command, the IS-IS metrics are similar to hop-count metrics.
775