Command Line Reference Guide
bootflash-image Upgrade the boot image in the bootflash partition.
bootselector-
image
Upgrade the boot image in the bootselector partition. You are
prompted to enter the password.
stack-unit
stack-
unit-id
Enter the keyword stack-unit followed by the stack unit ID of the
switch. Valid values are from 0 to 11.
booted: Upgrade using the boot image with which the S5000 booted up.
flash: After the keyword flash:, enter the location of the source file in the
internal flash in the format:
flash://filepath or press Enter to launch a prompt sequence.
ftp: After the keyword ftp:, enter the location of the source file in the
format:
//userid:password@host-ip/file-path or press Enter to
launch a prompt sequence.
tftp: After the keyword tftp:, enter the location of the source file in the
format:
//host-path/file-path or press Enter to launch a prompt
sequence.
usbflash: After the keyword usbflash:, enter the location of the source file
in the external flash in the format:
usbflash://filepath or press Enter to launch a prompt
sequence.
file-path
Enter the path and filename to be used to upgrade the boot image.
Defaults None
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must reload the switch after entering the upgrade boot command to boot up the
switch with the new boot code.
Example
FTOS#upgrade boot bootselector-image stack-unit 0 booted
Password:
Current BootSelector information in the system:
===============================================
Card BootSelector Current Version
New Version
---------------------------------------------------------------
---------
Unit0 Boot Selector
1.3.0.0 1.3.0.1
***************************************************************
********
77