Command Line Reference Guide

neighbor distribute-list
Distribute BGP information using an established prefix list.
S5000
Syntax
neighbor {ipv6-address | peer-group-name} distribute-list
prefix-list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ipv6-address | peer-
group-name} distribute-list prefix-list-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Enter the name of the peer group.
prefix-list-name Enter the name of an established prefix list. If the prefix list is not
configured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
neighbor filter-list – assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map – assigns a route map to a neighbor or peer group.
neighbor filter-list
Configure a BGP filter based on the AS-PATH attribute.
S5000
Syntax
neighbor [ipv6-address | peer-group-name] filter-list aspath
access-list-name [in | out]
To delete a BGP filter, use the no neighbor [ipv6-address | peer-group-
name
] filter-list aspath access-list-name [in | out] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
726