Command Line Reference Guide
neighbor activate
Allows you to enable a specified neighbor/peer group for the current address and subsequent address family identifier
(AFI/SAFI).
S5000
Syntax
neighbor [ipv6-address | peer-group-name] activate
To disable, use the no neighbor [ipv6-address | peer-group-name]
activate command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name
Identify a peer group by name.
activate Enter the keyword activate to enable the identified neighbor or
peer group in the new AFI/SAFI.
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
By default, when a neighbor/peer group configuration is created in the Router BGP context, it
is enabled for the IPv6/Unicast AFI/SAFI. By using activate in the new context, the
neighbor/peer group is enabled for AFI/SAFI.
Related
Command
address family – changes the context to SAFI.
neighbor advertisement-interval
Set the advertisement interval between BGP neighbors or within a BGP peer group.
S5000
Syntax
neighbor {ipv6-address | peer-group-name} advertisement-
interval seconds
To return to the default value, use the no neighbor {ipv6-address | peer-
group-name
} advertisement-interval command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
724