Command Line Reference Guide

redistribute ospf
Redistribute OSPFv3 routes into BGP.
S5000
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id
command.
Parameters
process-id
Enter the number of the OSPFv3 process. The range is 1 to 65535.
match external {1
| 2}
(OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify 1 or 2 to redistribute those
routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute
OSPFv3 internal routes only.
route-map
map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
match ipv6 address
match ipv6 next-hop
match ipv6 route-source
set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enter the redistribute ospf process-id command without any other
parameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and external
type 2 routes.
700