Command Line Reference Guide

A peer group must exist before you add a peer to it. If the peer group is disabled (shutdown)
the peers within the group are also disabled (shutdown).
Related
Commands
capture bgp-pdu max-buffer-size – resets BGP sessions.
neighbor peer-group (creating group) – creates a peer group.
show ip bgp ipv6 unicast peer-group – views BGP peers.
show ip bgp ipv6 unicast neighbors – views BGP neighbors configurations.
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
S5000
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-name Enter a text string up to 16 characters long as the name of the peer
group.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When a peer group is created, it is disabled (shut mode).
Related
Commands
neighbor peer-group (assigning peers) – assigns routers to a peer group.
neighbor remote-as – assigns a indirectly connected AS to a neighbor or peer group.
neighbor shutdown – disables a peer or peer group.
neighbor peer-group passive
Enable passive peering on a BGP peer group; that is, the peer group does not send an OPEN message, but does respond
to one.
S5000
Syntax
neighbor peer-group-name peer-group passive
687