Command Line Reference Guide

Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its
configuration takes precedence over the neighbor next-hop-self command.
neighbor peer-group (assigning peers)
Allows you to assign one peer to a existing peer group.
S5000
Syntax
neighbor ipv6-address peer-group peer-group-name
To delete a peer from a peer group, use the no neighbor ipv6-address peer-
group
peer-group-name command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group peer-
group-name
Enter the keywords peer-group followed by the name of a
configured peer group (maximum 16 characters).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can assign up to 64 peers to one peer group.
When you add a peer to a peer group, it inherits all the peer group’s configured parameters. A
peer cannot become part of a peer group if any of the following commands are configured on
the peer:
• neighbor advertisement-intervall
• neighbor distribute-list
• neighbor filter-list
• neighbor next-hop-self
• neighbor route-map
• neighbor route-reflector-client
• neighbor send-community
A neighbor may keep its configuration after it was added to a peer group if the neighbor’s
configuration is more specific than the peer group’s and the neighbor’s configuration does not
affect outgoing updates.
686