Command Line Reference Guide
maximum
Enter a number as the maximum number of prefixes allowed for this
BGP router. The range is 1 to 4294967295.
threshold
(OPTIONAL) Enter a number to be used as a percentage of the
maximum value. When the number of prefixes reaches this threshold,
the switch software sends a message. The range is 1 to 100 percent.
The default is 75.
warning-only (OPTIONAL) Enter the keyword warning-only to set the router to
send a log message when the maximum value is reached. If this
parameter is not set, the router stops peering when the maximum
number of prefixes is reached.
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If the neighbor maximum-prefix command is configured and the neighbor receives
more prefixes than allowed by the
neighbor maximum-prefix command configuration,
the neighbor goes down and the show ip bgp ipv6 unicast summary command
displays (
prfxd) in the State/PfxRcd column for that neighbor. The neighbor remains down
until you enter the capture bgp-pdu max-buffer-size command for the neighbor or
the peer group to which the neighbor belongs or you enter neighbor shutdown and
neighbor no shutdown commands.
Related
Commands
show ip bgp ipv6 unicast summary – displays the current BGP configuration.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
S5000
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-
group-name
} next-hop-self command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
Defaults Disabled.
685