Command Line Reference Guide

show ipv6 flowlabel-zero
Display the flow label zero setting.
S5000
Syntax
show ipv6 flowlabel-zero
Default Disabled
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ipv6 nd dad attempts – Configure system to set the flow label field in the packets to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
S5000
Syntax
show ipv6 interface type slot/port [brief] [configured] [stack—
unit unit-number]]
Parameters
interface type
slot/port
(OPTIONAL) Enter the interface keyword followed by the
interface type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are listed
below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
brief (OPTIONAL) View a summary of IPv6 interfaces.
645