Command Line Reference Guide

25
IPv6 Basics
IPv6 Basic Commands are supported on the Dell Networking S5000 switch.
NOTE: For information about the Dell Networking operating software (FTOS) version and platform that supports
IPv6 in each software feature, refer to the "IPv6 Addressing" chapter of the FTOS Configuration Guide .
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a stack-unit.
S5000
Syntax
clear ipv6 fib stack—unit unit-number
Parameters
unit-number Enter the keyword stack-unit followed by the stack-unit number
to clear the FIB for that unit. The range is 0 to 11.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
clear ipv6 route
Clear (refresh) all or a specific route from the IPv6 routing table.
S5000
Syntax
clear ipv6 route {* | ipv6-address prefix-length}
Parameters
* Enter the * to clear (refresh) all routes from the IPv6 routing table.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
635