Command Line Reference Guide

udp Enter the keyword udp to configure a User Datagram Protocol filter.
source address Enter the IPv6 address of the network or host from which the packets
were sent in the x:x:x:x::x format followed by the prefix length in the /x
format. The range is /0 to /128. The :: notation specifies successive
hexadecimal fields of zero.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject to the
filter.
host ipv6-address Enter the keyword host followed by the IPv6 address of the host in
the x:x:x:x::x format. The :: notation specifies successive hexadecimal
fields of zero.
operator (OPTIONAL) Enter one of the following logical operands:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports
for the port parameter.)
port port (OPTIONAL) Enter the application layer port number. Enter two port
numbers if using the range logical operand. The range is 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination
address
Enter the IPv6 address of the network or host to which the packets
are sent in the x:x:x:x::x format followed by the prefix length in the /x
format. The range is /0 to /128. The :: notation specifies successive
hexadecimal fields of zero.
message-type (OPTIONAL) Enter an ICMP message type, either with the type (and
code, if necessary) numbers or with the name of the message type .
The range is 0 to 255 for ICMP type and 0 to 255 for ICMP code.
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
monitor (OPTIONAL) Enter the keyword monitor to monitor traffic on the
monitoring interface specified in the flow-based monitoring session
along with the filter operation.
623