Command Line Reference Guide

Parameters
access-list-name Enter the as the access list name as a string, up to 140 characters.
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is
dropped.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed specification on
entries allowed per ACL, refer to your switch ocumentation.
Related
Commands
show config – views the current configuration.
permit
Select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP to configure a filter that match the filter criteria.
S5000
Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
• Use the no seq sequence-number command syntax if you know the filter’s
sequence number
• Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp
| udp} command
Parameters
ip-protocol-
number
Enter an IPv6 protocol number. The range is 0 to 255.
icmp Enter the keyword icmp to filter internet control message protocol
(ICMP) version 6.
ipv6 Enter the keyword ipv6 to filter any iInternet protocol (IP) version 6.
tcp Enter the keyword tcp to filter the Transmission Control Protocol.
udp Enter the keyword udp to filter the User Datagram Protocol.
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
Version 9.0(1.3) Introduced on the S5000.
614