Command Line Reference Guide

mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject to the
filter.
host ipv6-address Enter the keyword host followed by the IPv6 address of the host in
the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero. Only one occurrence of this notation is permitted in an IPv6
address.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports
for the port command parameter).
port port
Enter the application layer port number. Enter two port numbers if
using the range logical operand. The range is 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination
address
Enter the IPv6 address of the network or host to which the packets
are sent in the x:x:x:x::x format followed by the prefix length in the /x
format. The range is /0 to /128. The :: notation specifies successive
hexadecimal fields of zero.
bit Enter a flag or combination of bits:
• ack: acknowledgement field
• fin: finish (no more data from the user)
• psh: push function
• rst: reset the connection
• syn: synchronize sequence numbers
• urg: urgent field
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
609