Command Line Reference Guide

IPv6 Access Control Lists (IPv6 ACLs)

IPv6 ACLs and IPv6 Route Map commands are supported on the Dell Networking S5000 switch.

This chapter contains the following sections

• IPv6 ACL Commands

• IPv6 Route Map Commands

NOTE: For IPv4 ACL commands, refer to the Access Control Lists (ACL) chapter.

Important Points to Remember

• The S5000 requires manual CAM usage space allotment. For more information, refer to the cam-acl command.

• Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.

• Reference to an empty ACL permits any traffic.

• ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by IPv6 ACL

because the routed bit is not set for Control Protocol traffic and for egress ACLs the routed bit must be set).

• You can use the same access list name for both IPv4 and IPv6 ACLs.

• You can apply both IPv4 and IPv6 ACLs on an interface at the same time.

• You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).

• Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.

• Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.

IPv6 ACL Commands

The following commands configure IPv6 ACLs.

cam-acl

Allocate space for IPv6 ACLs.

S5000

Syntax

cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos

1-10 l2qos 1-10}

603