Command Line Reference Guide

show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
S5000
Syntax
show ip traffic
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes keywords in output for the show ip traffic command shown in
the Example below.
Keyword Definition
unknown
protocol...
No receiver for these packets. Counts those packets whose protocol
type field is not recognized by FTOS.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets that could
not be forwarded due to:
• route not found for unicast/multicast; ingress interfaces do
not belong to the destination multicast group
• destination IP address belongs to reserved prefixes; the host/
network is unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
... timeouts Number of times a timer expired on a reassembled queue.
... too big Number of invalid IP fragments received.
... couldn’t
fragment
Number of packets that could not be fragmented and forwarded.
...encapsulation
failed
Counts those packets which could not be forwarded due to ARP
resolution failure. FTOS sends an arp request prior to forwarding an
IP packet. If a reply is not received, FTOS repeats the request three
times. These packets are counted in encapsulation failed.
Rcvd:
...short packets The number of bytes in the packet are too small.
...bad length The length of the packet was not correct.
...no port
broadcasts
The incoming broadcast/multicast packet did not have any listener.
599