Command Line Reference Guide

show ip route summary
View a table summarizing the IP routes in the switch.
S5000
Syntax
show ip route summary
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show ip route summary shown in the Example below.
Column Heading Description
Route Source Identifies how the route is configured in FTOS.
Active Routes Identifies the best route if a route is learned from two protocol
sources.
Non-active
Routes
Identifies the back-up routes when a route is learned by two different
protocols. If the best route or active route goes down, the non-active
route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are
advertised, then information on those routes is displayed.
Total 1388
active...
Displays the number of active and non-active routes and the memory
usage of those routes. If there are no routes configured in the FTOS,
this line does not appear.
Example
FTOS>show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
FTOS>
Related
Commands
show ip route – displays information about the routes found in the switch.
598