Command Line Reference Guide

brief (OPTIONAL) Enter the keyword brief to view a brief summary of the
interfaces and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical
interfaces with non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output for the show ip interface command shown in the
Example below.
Field Description
TenGigabitEthern
et 0/0...
Displays the interface’s type, slot/port, and physical and line protocol
status.
Internet
address...
States whether an IP address is assigned to the interface. If an IP
address is assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any configured incoming access list. If none
is configured, the phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface.
ICMP redirects... States if ICMP redirects are sent.
ICMP
unreachables...
States if ICMP unreachable messages are sent.
Example
FTOS#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
FTOS#
Usage
Information
The following describes output for the show ip interface brief command shown in
the Example below.
Column Heading Description
591