Command Line Reference Guide

The show ip flow command does not compute the egress port information when load-
balance mac hashing is also configured due to insufficient information (the egress MAC
is not available).
The S5000 produces the following error message: %Error: Unable to read IP
route table.
Example
FTOS#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol
tcp source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Te 1/20
Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710]
unfragmented packet
Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented
packet
show ip interface
View IP-related information on all interfaces.
S5000
Syntax
show ip interface [type slot/port | brief | stack—unit unit-
number] [configured]
Parameters
interface type
slot/port
(OPTIONAL) Enter the interface keyword followed by the
interface type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are listed
below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
• For a stack-unit, enter the keyword stack-unit followed
by the stack-unit number. The range is 0 to 11.
590