Command Line Reference Guide
Port VId EC
-------------
BLK HOLE 0 0
FTOS>
Related
Commands
clear ip fib stack-unit – clears the FIB entries on a specified stack-unit.
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
S5000
Syntax
show ip flow interface [type slot/port {source-ip-address
destination-ip-address } {protocol [tcp | udp | number ]}
{source-port port-number destination-port port-number}
Parameters
interface
type
slot/port
Enter the keyword
interface
followed by of the following interface
keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
source-ip-
address
Enter the source IP address.
destination-ip-
address
Enter the destination IP address.
source-port
port-
number
Enter the keywords
source-port
followed by the source port number.
destination-port
port-number
Enter the keywords
destination-port
followed by the destination port
number.
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command provides egress port information for a given IP flow. This is useful in identifying
which interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use
this command for routed packets only. For switched packets, use the show port-
channel-flow command.
589