Command Line Reference Guide

show ip fib stack-unit
View all FIB entries.
S5000
Syntax
show ip fib stack-unit unit-number [ip-address [mask] [longer-
prefixes] | summary]
Parameters
stack-unit unit-
number
Enter the keyword stack-unit followed by the unit number. The
range is 0 to 11.
ip-address mask (OPTIONAL) Enter the IP address of the network destination to view
only information on that destination. Enter the IP address in dotted
decimal format (A.B.C.D). You must enter the mask in slash prefix
format (/X).
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all
routes with a common prefix.
summary (OPTIONAL) Enter the keyword summary to view the total number of
prefixes in the FIB.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show ip fib stack-unit command shown in the Example
below.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a directly
connected route or the remote IP address to be used to forward the
traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
EC Displays the number of ECMP paths.
Example
FTOS#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr
------------------------------------------------------
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00
588