Command Line Reference Guide

show ip cam stack-unit
Display CAM entries for the S5000 switch.
S5000
Syntax
show ip cam stack-unit unit-number port-set pipe-number [ip-
address mask [longer-prefixes] | ecmp-group | member-info |
detail | summary]
Parameters
stack-unit unit-
number
Enter the keyword stack-unit followed by the unit number. The
range is 0 to 11.
port-set pipe-
number
Enter the keyword port-set followed by number of the port-pipe.
Values are 0 or 1.
ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries
for that route only. Enter the keyword longer-prefixes to view
routes with a common prefix.
detail Enter the keyword detail to display the group index ID used by the
ecmp routes in the CAM.
member-info Enter the keyword member-info to display the group index used
by the ecmp, the number of egress ports (members) for the ecmp, and
the port details of each member. The detail information under
member-info gives the MAC address, VLAN ID, and gateway of every
member port of the ecmp.
summary (OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show ip cam command shown in the Example below.
Field Description
Destination Displays the destination route of the index.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is
forwarded to the CP depending on egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
586