Command Line Reference Guide

management route
Configure a static route that points to the Management interface or a forwarding router.
S5000
Syntax
management route {ipv4-address | ipv6-address}/mask
{forwarding-router-address | managementethernet}
Parameters
{ ipv4-address |
ipv6-address }/
mask
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X), followed
by the prefix-length for the IP address of the management interface.
NOTE: The :: notation in an IPv6 address specifies successive
hexadecimal fields of zero. Only one occurrence of this notation is
permitted in an IPv6 address.
forwarding-
router-address
Enter an IPv4 or IPv6 address of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management
interface on the Primary Stack-unit.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static
route (or a protocol route) is preferred over the Management Static route. Also, Management
static routes and the Management Connected prefix are not reflected in the hardware routing
tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This
command manages both tables.
Related
Commands
interface ManagementEthernet – configures the Management port on the system (either the
primary or standby stack-unit).
duplex (Management) – sets the mode of the Management interface.
speed (Management interface) – sets the speed for the Management interface.
show arp
Display the ARP table.
S5000
Syntax
show arp [inspection | interface type slot/port | ip ip-address
[mask] | macaddress mac-address [mac-address mask] | retries]
[static | dynamic] [summary]
581