Command Line Reference Guide

ip proxy-arp
Enable proxy ARP on an interface.
S5000
Syntax
ip proxy-arp
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
show ip interface – displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
S5000
Syntax
ip route {[ destination | mask | ip-address | interface-type
slot/port | distance ]} [permanent] [tag tag-value]
To delete a specific static route, use the no ip route destination mask
{address | interface-type slot/port [ip-address]} command.
To delete all routes matching a certain route, use the no ip route destination
mask
command.
Parameters
destination Enter the IP address in dotted decimal format of the destination
device.
mask Enter the mask in slash prefix formation (/x) of the destination
device’s IP address.
ip-address Enter the IP address in dotted decimal format of the forwarding
router.
interface-type
slot/port
Enter the interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
577