Command Line Reference Guide
The access-group option supports only the equal to (eq) operator in TCP ACL rules. Port
operators not equal to (neq), greater than (gt), less than (lt), or range are not supported in
access-group option (refer to the Example below). ARP packets (
arp) and Ether-type
(ether-type) are also not supported in the access-group option. The entire rule is
skipped to compose the filter.
The access-group option pertains to:
• IP Protocol Number: 0 to 255
• Internet Control Message Protocol (icmp) but not the ICMP message type (0-255)
• Any Internet Protocol (ip)
• Transmission Control Protocol (tcp) but not on the rst, syn, or urg bits
• User Datagram Protocol (udp)
In the case of ambiguous access control list rules, the debug ip packet access-
control
command is disabled. A message appears identifying the error (refer to the Example
below).
Example (Error
Messages)
FTOS#debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
FTOS#00:10:45: %STKUNIT0-M:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is
turned off
FTOS#
ip address
Assign a primary and secondary IP address to the interface.
S5000
Syntax
ip address ip-address mask [secondary]
To delete an IP address from an interface, use the no ip address [ip-address]
command.
Parameters
ip-address
Enter an IP address in dotted decimal format.
mask
Enter the mask of the IP address in slash prefix format (for example, /
24).
secondary (OPTIONAL) Enter the keyword secondary to designate the IP
address as the secondary address.
Defaults Not configured.
569