Command Line Reference Guide
ip helper-address hop-count disable – disables the hop-count increment for the DHCP relay
agent.
debug ip icmp
View information on the internal control message protocol (ICMP).
S5000
Syntax
debug ip icmp [interface-type slot/port] [count value]
To disable debugging, use the no debug ip icmp command.
Parameters
interface-type
slot/port
(OPTIONAL) Enter the interface type followed by slot/port or number
information. Valid slot numbers are 0-11. The valid port numbers for
each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
count
value
(OPTIONAL) Enter the keyword count followed by the count value.
The range is 1 to 65534. The default is Infinity.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
566