Command Line Reference Guide
To enter MULTIPLE SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree mstp command.
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
You must use PROTOCOL GVRP mode to enable and configure GARP VLAN Registration Protocol (GVRP). For more
information, refer to GARP VLAN Registration (GVRP).
To enter PROTOCOL GVRP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol gvrp command.
You can return to CONFIGURATION mode by using the exit command.
ROUTER OSPF Mode
You must use ROUTER OSPF mode to configure OSPF. For more information, refer to Open Shortest Path First (OSPFv2).
To enter ROUTER OSPF mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router ospf {process-id} command. The prompt changes to include (conf-router_ospf-id).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER RIP mode by
using the router rip command.
ROUTER RIP Mode
You must use ROUTER RIP mode to configure RIP on the S5000. For more information, refer to Routing Information
Protocol (RIP).
To enter ROUTER RIP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router rip command. The prompt changes to include (conf-router_rip).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER OSPF mode by
using the router ospf command.
ROUTER ISIS Mode
You must use ROUTER ISIS mode to configure intermediate system to intermediate system (ISIS) on the S5000. For more
information, refer to the Intermediate System to Intermediate System (IS-IS) chapter in the
S5000 FTOS Command Line
Reference Guide
.
To enter ROUTER ISIS mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router isis [tag] command. The prompt changes to include (conf-router_isis).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER RIP mode by
using the router rip command.
56