Command Line Reference Guide

show fc switch
Display the switch configuration for Fibre Channel capability.
S5000
Syntax
show fc switch
Parameters None
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show interfaces fibrechannel command to display information on the Fibre
Channel capability of a switch.
The following table describes the show fc switch output shown in the following example.
Switch Mode Fibre Channel mode of operation of an S5000 switch. Default: NPG
(configured as an NPIV proxy gateway).
Switch WWN Factory-assigned worldwide node (WWN) name of the S5000. The
S5000 WWN name is not user-configurable.
Example
FTOS# show fc switch
Switch Mode : NPG
Switch WWN : 10:00:5c:f9:dd:ef:10:c0
FTOS#
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show interfaces fibrechannel — displays the configuration of a Fibre Channel interface.
speed
Set the speed of a Fibre Channel port or configure the port to auto-negotiate its speed with a peer.
S5000
Syntax
speed {auto | 2G | 4G | 8G}
Parameters
auto The port autosenses the speed of a peer FC port .
2G Port speed is 2 gigabits per second (Gbps).
4G Port speed is 4 Gbps.
556